PDA

View Full Version : Magnetic Brakes



MP&C
11-10-2015, 07:31 PM
I think Laszlo and Nick had asked before about using a mag brake for heavier gauge in making brackets. I was working on some frame plates tonight and had some scraps left over so I bent a piece to see how well the Mag brake did. Here's the brake...

http://i5.photobucket.com/albums/y167/rmccartney/Metalworking/Picture%203716.jpg

This is a bit proud for 12 ga so likely it is a thin version of some 11.

http://i5.photobucket.com/albums/y167/rmccartney/Metalworking/Picture%203711.jpg

The section bent was about 6" across...

http://i5.photobucket.com/albums/y167/rmccartney/Metalworking/Picture%203712.jpg

http://i5.photobucket.com/albums/y167/rmccartney/Metalworking/Picture%203713.jpg

Where it wasn't a perfectly tight bend, I was rather impressed that the inside radius was only about 1/16"

http://i5.photobucket.com/albums/y167/rmccartney/Metalworking/Picture%203715.jpg

http://i5.photobucket.com/albums/y167/rmccartney/Metalworking/Picture%203717.jpg

Keep in mind whenever you get to the upper limits on a mag brake, additional "anvils", or whatever they're called, will help to give the magnet more to pull against so the work piece is less likely to pull upwards when bending..

http://i5.photobucket.com/albums/y167/rmccartney/Metalworking/Picture%203718.jpg

So if that width and inside radius is OK with you, then the 4816 may work for you. In looking at an ad this morning for the Roper Whitney version of this brake, they advertise bending smaller widths up to 10 ga steel.

NickP
11-11-2015, 07:33 AM
Very cool Robert, many thanks for your time!

chevynut
11-11-2015, 08:04 AM
That's pretty impressive Robert. I don't bend anything much thicker than 16 gauge at this point, and when I do I use my press brake. I have a JET 4816 finger brake that's supposed to bend 16 gauge steel 48" wide and there's no way it will do that. It does okay for most of what I do, but I'm kind of disappointed at the lack of rigidity in the machine. Part of the problem is that it's a finger brake and doesn't have a one-piece upper jaw. The jaws slide on the metal as they clamp down, which is a real pain when you're trying to make accurate bends. We had a 48" Pexto or Roper Whitney machine at work and it was incredibly rigid.