1956 radiator

Anyone running a radiator in front with inlet on top of the support I have a 56 how much room do I have just checking before cutting Thanks Raybob

The top of the radiator should be mounted flush with the top of the radiator support. The only potential problem you'll have is the diagonal support rods that run from the side of the hood at the baffle to the latch area - interfering with the radiator cap if it's above the crossbar. This is usually not a problem with a 56-57 but almost a certainty with a 55. It's close though, I did see this happen on a 57 recently where the radiator was moved forward off the support for another clearance issue. The solution is either to lower the radiator cap by cutting a diagonal on the tank, or to fabricate a curved support rod.

I'll show you mine. Attachment 9777Attachment 9778Attachment 9779

I perhaps mistakenly thought that the question was about a crossflow radiator conversion. Carl's post made me realize that this may not be so, that the question was about mounting a stock style radiator in the 6 cylinder position in front of the radiator support. If that was the question, then look at Carl's photos for details. For that case, the radiator should be no higher than his, the top hose should be positioned low enough that it clears the stock hood baffle but high enough that the hose clears the radiator support.