So I could paint the hood and the door that is ready to go I bought a couple of the folding work stands from Harbor Freight which worked out nicely.
http://www.trifivechevys.com/cdn-cgi...28-jpg.326424/
https://www.trifive.com/cdn-cgi/imag...28-jpg.326424/
Hood and door painted on the inside.
http://www.trifivechevys.com/cdn-cgi...45-jpg.326425/
https://www.trifive.com/cdn-cgi/imag...45-jpg.326425/http://www.trifivechevys.com/cdn-cgi...14-jpg.326426/
https://www.trifive.com/cdn-cgi/imag...14-jpg.326426/
Hood and door flipped over to get a couple coats of epoxy on the outside.
http://www.trifivechevys.com/cdn-cgi...16-jpg.326427/
https://www.trifive.com/cdn-cgi/imag...16-jpg.326427/
The last part I have ready to go right now is the drivers side rear fender. Since this is lighter weight I hung it up so I could paint both sides at the same time.
http://www.trifivechevys.com/cdn-cgi...34-jpg.326428/
https://www.trifive.com/cdn-cgi/imag...34-jpg.326428/http://www.trifivechevys.com/cdn-cgi...52-jpg.326429/
https://www.trifive.com/cdn-cgi/imag...52-jpg.326429/
A couple of coats of the 5311 Direct to Rust sprayed on. The direct to rust sprays pretty nice also but you do need to use a 1.8 to 2.0 tip depending on your mix ratio. You can use is as a sealer also by using more reducer. I dries fast and sands pretty easy as well.
http://www.trifivechevys.com/cdn-cgi...28-jpg.326430/
https://www.trifive.com/cdn-cgi/imag...28-jpg.326430/
Inside of the fender sanded out ready for epoxy. Just basically scuffed it good on the inside so any rust that was left would be sealed up well.
http://www.trifivechevys.com/cdn-cgi...08-jpg.326431/
https://www.trifive.com/cdn-cgi/imag...08-jpg.326431/
The outside I bock sanded it out to just leave the DTR in the rust pits and low spots.
http://www.trifivechevys.com/cdn-cgi...43-jpg.326432/
https://www.trifive.com/cdn-cgi/imag...43-jpg.326432/
http://www.trifivechevys.com/cdn-cgi...31-jpg.326433/
https://www.trifive.com/cdn-cgi/imag...31-jpg.326433/
And finally a couple coats of epoxy inside and out.