Have you stopped building frames permanately ?
Type: Posts; User: Rustaddict
Have you stopped building frames permanately ?
Does this site give you the ability to delete unwanted posts out of your thread?
C-Nut, I rarely post but I'm enjoying watching your car come together and the detail you show. It's turning out to be super nice.
yes, the R is for resistor.
how did you blow your original rear end ?
Just shooting off the hip, are you sure your timing is right? Have you tried advancing it a little more to see if theres an improvement?
I second that.
Robert, Are you making your door panels out of sheet metal ?
That is a good looking car. You've got something there to be proud of
I have no experience with either.
To the best of my knowledge, no one is making a 9 passenger fuel tank. You'll have to repair what you have. If I were using the 97 vortec and auto trans, I'd put an intake manifold & carburetor on it...
yes the water pump turns backwards on factory set ups. Not sure about aftermarket set ups.
I always believed that ideally the fan shroud dictated how far from the radiator the fan should be. I...
Is it a used GM or aftermarket serpentine set up ?
I dont think having a 57 linkage has anything to do with the oil filter clearance. The benefit of the 57 stuff is it is a better design than the first 2 years. You need a 57 Z bar if you get 57 lower...
You're welcome. I was just kidding I know a few people. One thing I will add is I had to take a die and cut the threads a little farther down the shaft and shorten the threaded end of the rod a...
I dont have any friends. I was doing the best I could with what I have to work with.
The throttle is wide open. I was by myself and checking for wide open throttle when I floored the gas and since I could'nt be at the carb and on the gas pedal at the same time, I leaned out of the...
For comparison's sake heres mine. I have the east coast chevy rod. 11673
Could you open the hole up a little bit and go with the 7/16 bolt ?
East Coast Chevy ( and others ) sell the correct rod that goes from the firewall rod to the carb. I'm using that replacement rod on a Holley with no trouble.
We used to have a place local that taught disadvantaged people trades and they did sandblasting fairly cheap. Maybe you could spot blast the rust and scuff the rest. I live on the east coast and salt...
The thing is, the clearance is so tight between the floor and the bench seat that it dosent really leave much room for the modifications you'd need to do. If your money is tight, it is possible to...
Sweet. How much do you know about it?
I have use both over self etching primer and they seemed to hold up well. This was before I knew epoxy primer existed and there's no doubt that Epoxy primer is the superior product to use these days....
Here's another suggestion to buy new 57 clutch linkage and be done with it