Search:

I'm following this thread and i'm learning from it. Some of this is beyond me know but it's soaking in as you go. I'm looking forward to your conclusions( table/chart) on the affects of different...

My front wilwood brakes on my 55 will not fit in a 8 inch vette rally wheel. Some wheels, on the back of the wheel, have a step up as it goes toward the mounting surface, and this creates the...

Thanks everyone for your experiences and advice.

I'm getting ready to build power steering hoses. I saw two tri-five's at Bowling Green with braided power steering hoses blown off their a/n fittings. Is there a problem with this material for power...

Like this site for great car Knowledge and help, not vulgar jokes.

I cut off short pieces of a bolt or all thread. After that I use a cut off wheel to cut a slot in one end and install them into threaded holes with a screwdriver. This saves me a lot of clean up/...

I have Heidts tubular arms, wilwood disc, and dropped spindles on a 55. I wanted to run 15x8 Torque Thrust 2 wheels but the 3.75 backspace did not fit in the front tire calculator in a lowered car...

How does the seat height compare to the original seat , does it sit lower than stock

That improves the appearance a lot, nice fabrication job.

Wow, that rusted like everyday steel, powder coating sure made a difference.

The car looks sleeker without the wind lace. Thanks for the history on wind lace. The seats in the picture of the yellow/ white car interest me. They sit low and I'm tall, looks like a good option....

Thanks for the information and the photos also. You have put a lot of nice detail in your motor.

What filter brand and specs did you go with?

I would be interested in the responses also, need to buy one for a big block 620 hp