Figured it out,thanks!
Type: Posts; User: jollyold
Figured it out,thanks!
Hello.I searched under windlace here and could not find help on the flap that is suppose to tuck into dash.I am installing the windlace and have it in the groove but do not get the concept of the...
Thank you!
I have the round rubber on the jamb {2} for the door to close to but this is on the door frame facing forward.Is that suppose to have a bumper to?Thanks
First,thanks for all the help.My project has been quite the challenge.I was putting on the door weatherstrip and noticed on both doors on the front upper frame front there is a factory hole in both...
Yes,thats the problem,I do not know how it was designed to go on.Anyone with pics?Thanks
Hello again.I am attempting to install this small silver bent clip over the lever that goes on the frame.I installed the new {2| bushings and can't figure from the pics whether the clip goes bent...
Hello.First time I have done a tri five and I am confused on the foam from Ciadellas in Tempe.I have done other seats but the foam is extremely thick and two layers.Second layer is thinner and is...
I will be reinstalling my original metal oil canister back on soon.It has an original copper washer on the bolt and the cone washer inside.Is there a torque for this?Cant find anywhere and I want to...
Ummmm....O.K..I looked at my speaker grill and it has 2 small studs on the bottom and a place for 2 screws that screw into bottom side of dash.Nothing like you are describing.Any one have pics?The...
Hello.I have a stock AM 56 chevy radio and new mounting bracket to go into my 56 chevy 210.It says to mount brace to plenum chamber bracket??I cant see any brackets on heater assembly or defroster...
Hello.Looking for a rear seat frame lower for my 56 2 door sedan no curved front corners.I am in Tucson zip 785742.THANK YOU!!!!!!
Hello.I need a lower rear seat for my 56 2 door post.Anyone.I am in Tucson 85742
Looking for a correct 4 Barrel Air Cleaner for my 56 V8 265.I don't need the oil part insides in that I will be running the paper element now available.Dont want the 56 because you have to cut a...
Emailed the GM Heritage Center.Correct number is 3722234 for trunk...It does have the notches and hood V does not.Hood V number is 3722456.Hope this helps others because there are those out there...
Pic did not come through.Seen them with finger grips for raising the trunk lid?
My assembly manual omitted page 17 that is supposed to have rear emblem info.To my understanding the V is suppose to have finger grips to raise trunk lid?Any help there would be greatly...
So what is the price?
I dont know what to offer,just tell me what you want and I will either pass out or pay you
Nice ride you are building!Did you find me a 56 hood bar?Thanks
Thank you....and thanks for looking for a hood bar!
Yes....most I have run into are broken so I need one that is in good shape so if I want to chrome later I can.Thanks!
Hello.Looking for an original chrome hood bar for my 56 chevy 210.In good condition.It does not matter about how good the chrome is but no or very little rust.Thanks
Hello.I am looking for an original chrome hood bar for my 56 chevy 210.Hope this is the right place to post this?Thanks
New to the site.I have a 56 chevy 210 and assembly book shows trim plate on a model 2400 in book.Mine does not have one and do not know if it should.I see these in after market in 3 piece of...