Search:

I am so EXCITED !! Just got my full "Magnaflow " exhaust system from Danchuck ! 750$ later ! It doesn't fit ! the X pipe system is at least 4 to 5 inches to narrow at the collectors... no pix...

thanks Rick, I'm mocking that up right now , using the 5.5 inches that I cut out for the " cutouts ". my thoughts exactly - lengthen the pipe from the X before the bend to widen the inlet pipe . I...

Exhausting situation !! I purchased a "Magnaflo" system from a socal Tri Five company. Santa Ana... It is a clamp together system w/ X -pipe , made for a 57' Bel Aire, 2dr hrdtp. Now the New...

My bad, it is not aluminum, its cast steel. I went by the NAPA store this morning and the clerk looked on his computer for the fork I took in and could not find it anywhere. I saw 8 to 10 pics on...

mountain MAN , don't have that technology

when I bought my 57 Bel Aire in 83' the owner told me it had a 327 vette motor … Two motors later.... my clutch fork is causing problems. It is flat and made from aluminum I think , grooved out on...

Personally , I like my hearing … Ringing and all . So I'm installing my Magnaflow system on my 57' all the way out the back , but I am looking to install "Cutouts" . The question is where in the...

Thanks for the input, I do have a shop manual but I like first hand , hands on smarts sometimes... Experience is a great advantage ! Poly or Rubber any thoughts ?

Got any ? I need to replace all of the front end rubber, or whats left... I have gotten the poly kit from Danchuk, idler arm, springs . I do have access to a press but wondering if I need special...

Thanks Rocky, I am looking into the "Pertronix" Flamethrower distributor ,because the HEI that is included with the motor is too big...

hello all, I am looking to install a "Blueprint Engines" motor in my 57'. Does anyone have any experience with these motors, glitches, install problems ? 383... 420 hp Any suggestions