Wow first I have seen of the show in May. I will look into being there as well. Thanks - Dave
Type: Posts; User: Five Seven
Wow first I have seen of the show in May. I will look into being there as well. Thanks - Dave
Support Red, Radiator to match the color on the coil packs.....
I am a little late to this discussion but your questioning the fuse strategy is spot on. I have a VA unit and the hot water solenoid is tied to the switched power and not properly fused. I have an...
No problem. I have the HP ECU.
8802
For what its worth here is a picture of my timing map. Granted I have a stock zz502 cam. While I am still working to optimize it, I can say the car runs strong throughout and will run at...
The vision I had for mine was to turn down as yours did and not see them. What Earle did was rotate them to the side I assume to avoid exhaust from kicking up dust. When looking at them from the back...
I agree, made it a point to put in a 12 bolt. Its a TKO600 5spd. The tank is from Rock Valley, centered using a kit from Earle.
Thought I would share some pics of my recently completed exhaust system. I was lucky enough to have Earle Williams's shop complete the work. We used magna flow 14" with 3" to muffler and 2.5" to the...
Thanks everyone for the input.
I have tin snips, angle grinder, typical hole cutters in the 4 inch range. I have been doing a bit of sheet metal work, but never large holes.
Sorry guys I have been traveling. I have an air compressor and don't mind buying additional hand tools. I am working with 18 gauge steel.
I am trying to make a fan shroud for 14 inch fans and I am not sure how to go about cutting the large holes. Is there a particular tool I should use that would work best? Thanks in advance.
Great videos. I'm happy with how it sounds although I am running a temporary exhaust system. I'm curious to see how a full system with a crossover tames it down.
Just curious if you are planning to upgrade your EFI unit to an HP. I am running a stock ZZ502 with MPFI/Vic Jr manifold and a holley HP system. It works well, the self learning feature is important...
My take on this is they are two different issues. I buy into what the sound deadner show down site is trying to put out there. You do not need 100% coverage to reduce panel vibrations. That is what...
I will add my experience to this thread hoping it helps others. I spent quite a bit of time reading about what is available in the market etc.... My 57 doesn't have an interior (it will soon, at the...