Thanks for the info, I am going to have at it tomorrow I post some before and after pitchers
Type: Posts; User: turk1955
Thanks for the info, I am going to have at it tomorrow I post some before and after pitchers
Well theirs isn't any that I can see, can't even see any weld marks even where the wings would have been.
So my 201 didn't come with a hood bird so I picked one up now comes the neverous part mounting it, is their a pattern I can pickup so I know I am drilling in the correct locations ?
yes
You by chance have a part # for that OTC bleeder
yep
Ok so today I spent at least 4hrs gravity bleeding the rear brakes and at first the pedal felt great so I had the wife get in and do the pedal while I opened the far bleeder just to make sure all the...
Ok forgot to mention that I did replace both rear wheel cylinders
Ok but before I do that I have a question, this setup was on the car when I bought it and all was good till just about a month ago when I noted it started pulling a little to the left and on...
Ok so got a problem, my 55 210 has disks up front and drums back I found a bad spot in the line leading back to the rear and replaced the bad section also found one bad wheel cylinder driver side...
Thanks for all the info, I was able to get back ahold of the last owner and he used DOT 4 so that's what I am going to use.
So my 55 has front disks and factory rear drums brakes and I found a leaking rear wheel cylinder and need to replace it so heres my question: I am not sure what # brake fuild to use as the car had...
Thanks for the reply, not looking for big sound eather just the look as it looks shitty with that DIN in it.
So my 55 came with a DIN radio in it (yep last owner removed the stock radio and cut the dash :cry:) anyway I thinking about removing it and installing one of the aftermarket radios that look like...
Thanks so much for the replies, going to measure the rear tomorrow and make sure everything is set to stock and go from their.
Ok so my 55 came with American Racing Wheels 15"x8"x4" BS and I am trying to put the widest tire I can on the rear, the car has the stock rear on it I am thinking a 255/60R15 will work ?
Gots ta keep wife happy though I am still on the fence on changing to an auto thinking if I can find the proper hydraulic setup I mite say with the 4 speed just seems to to a lot of + and -'s on...
Thanks for all the info, at this time I am thinking hard on switching to a 700R as it would make it easer for the wife to drive, still on the fence as the $$ to make this change is up their.
Ok so decided to change to a hydraulic McLeod 1434001 kit but I have a question, what throw-out bearing to use anyone running this setup that can give me a part #
I checked into the Hooker's p/n 2112 and was told that they wouldn't fit with straight plug heads, as far as removing the bell housing mounts that's not a problem as I have installed a trans...
Thanks for all the info and ideas, think first I am going to install my new Z-Bar setup and try moving the upper link over just a little and see if that works as that will be my cheapest option.
Ok so after doing some research I have found that the power steering box is not a 605 but a Delphi 600, so with that being said is their a clutch linkage that will work with it?
917391749175 Ok guys I added some more pitchers of my clutch linkage and it looks like the point where the clutch pedal rod connects to the Z-bar has been shortened to miss the steering box, now I...
Thanks for the info, can you tell me whats the best side mounts to use ?
Anyone running Hooker long tube headers on their 55 that has a small block motor thats still has the front motor mounts, bell housing mounts, heads with straight plugs, and a 4 speed ? any problems...