That's what I thought. I've never changed them before so best to ask. I know I need axle flange gaskets too but didn't think I needed the wheel seals.
Type: Posts; User: bobbybelair
That's what I thought. I've never changed them before so best to ask. I know I need axle flange gaskets too but didn't think I needed the wheel seals.
timken 70 bucks, SKF 115 bucks. I asked Rockauto about origin but they said they will not and cannot say where they are made as products are produced globally.
I'm looking to pick up some new rear bearings for my 57. When I go to Rockauto and put RW307R bearings in my basket, there is a message that you should install new wheel seals with the bearings along...
Wow, lots of nasty going on here lately. I'm gonna need my safe space.....lol.
Combo cork/nitrile gasket, with Permatex 2 both sides, will not leak.
I've used Trim Parts gauge lenses and they are fine.
Love to see a pic of it.
Got mine at 17, but I was a late bloomer.
For better pics, here is a link to the auction listing.
http://www.ccpauctions.com/lot-details.php?RefNum=r023&EventID=92
The coral looks much better in person than in pics. Check out the...
at the Fall classic car auction here in Toronto today. 34k Canadian 26K US. Very clean restored, original 265 and glide, power steering, brakes. Some may not like the colour combo but I do....
I think I want that car.
Just buy that one in the meantime, she'll stay off your case!
What is the likelihood of my flex plate ticking the starter under load, causing my rattle? It sure sounds like it is coming from that area. Before I drop the starter thought I'd ask. Original...
I'm moving my timing/distributor thread back here for a current summary.
I put electronic points and a new coil (Pertronix both) in. Set timing at 10* initial, which is where it seems to run best....
Oh, believe me, I remember!
I have been expecting cnut to recommend Skip White any second now!
Looking for a recommendation for an HEI distributor. Stock 283 4 barrel WCFB.
That's what I was thinking too. But I don't expect to be lowering so I might be able to duck that.
That is what I thought. Mark, it's a stock 283 so it is mild.
I have a buddy who thinks my cam has at least one lobe problem. I put a vacuum gauge on and it gave a super steady reading of 20, right in the middle of the "good" range. I blipped the throttle...
Good to know, don't want to lower the car, and when the day comes, I might not have to spend time with the sawzall.
I am trying to source a 700r4 for future installation. Is it necessary to remove the Powerglide frame mount horns - I think it would be for clearance but not sure.
Welcome, I don't know whether to be more jealous of your cars or your garage.
Looks to me that the Permatex Ultra Black would be the one to use then.
I have seen a lot of discussion about what type of RTV to use when installing a new main seal, or whether to use it at all, and where to apply it. Ideas? I know the Best Gasket 3711x is considered...