It's no better this morning on the site still most photos only end up as a blue box with a ? mark in it.
Type: Posts; User: 56ls408
It's no better this morning on the site still most photos only end up as a blue box with a ? mark in it.
The MSD ignition has nothing to do with the charging system generator voltage regulator.Since you are replacing the wiring harness I would consider replacing the current generator v regulator with...
Plenty of room if you disconnect the idler arm from where it mounts to the frame then pull the drag link down.It may without doing that I've always just done that way.
I could be completely wrong but I've never seen any difference in front seats between bel air & 150 or 210 likely the difference in the rear seats are between a hard top & post car.4 door seats...
I always heard that concerning Keith Black pistons isn't that due to the ring being closer to the top of the piston more heat so needs larger ring gap but hadnt heard that about hyperutectic like...
the internal clutch piston seals will get hard as a rock after sitting long periods maybe yours haven't since it hasn't been heat cycled but i wouldn't put it in without at least pulling the front...
I really enjoyed reading your thread & viewing your work on the other site don't like the new platform but will see where it goes once I was finally able to get back on under the 56LS408 username...
used they're 3.75 crank & I beam rods in a 383 balanced well no issues I felt the rods were a nicer set than Eagle's I beams also used a set of I beams in a small journal L79 327 in a 65 vett i had...
i'm certainly no expert the base portion to me goes on a lot like lacquer the clear is usually where you normally get the runs Maybe a small detail gun might help in the tight areas if the windshield...
It started life as a 6.0 truck block I bought the stroker 4" crank & rods from Molnar Technologies he founded K1 before selling the company quality parts weisco pistons Ported Ls3 heads I probably...
thanks for the welcome guys I've had my 56 going on 4 years this fall I had done some work on the car a few years before for the previous owner fuel tank carb & new wiring harness I thought about...
new member I recognize a few usernames from another site