Well yesterday I heard a pop, then car wouldn't move. I guess the 600 hp and drag radials did its job! I took out the rear end last night and installing Ride Tech 4 Link with coil overs. I already have a 9" with late model flanges and Strange axles with rear disc. Just need time and money! I knew it was on borrowed time.
Sweet! But no pics of the damege........................................ bummer.
Have not taken apart! Concentrating on installing the new stuff
I have some updates. Just received my center section (HRW Nodular Case with Detroit Locker 3:70) and aluminum pinion support. The Ride Tech 4 Link is installed. I spot welded the 4 link brackets on and took housing to Peyton Performance from them to install in jig and finish welding up and pressing on wheel bearing to my Strange axles. With Nick P recommends, installed filler and drain. Also will be welding a jack pad on the bottom of housing. Starting tonight putting it all together and installing prop valve and new brake lines too the NEW rear caliper setup!
UHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH HH, PICTURES OF PROGRESS PLEASE!
Originally Posted by NCW
Yes I need too. The housing and center section is installed! They installed the axle seals of the outside of the bearing instead of the inside! This put me 1/4 more from the inside axle flange to the inner side of the bearing. Need to see how much of the teeth are making contact with the center section?
Hold on a sec! The seal is where? Picture please?
Here is some progress pics!photo (8).jpgphoto (22).jpgphoto (21).jpgphoto (23).jpgphoto (20).jpg
nice progress.
ARMY NAM VET, very proud!
56 210 4dr
drive and enjoy them while you work on them, life is to short.
Thanks Carl...its getting there
Posting Permissions
Reply With Quote
