how do i measure axles.from what point to what point. also what legenth will i need for a 57 housing. thank you
how do i measure axles.from what point to what point. also what legenth will i need for a 57 housing. thank you
i am using a 57 housing. i did not see a # on it but it dose have the drain plug on the bottom. the center section has a casting # 3707806. cast date 128. it has an O on it about 2 inches up the case from the casting #. i was told that ment it was an early posi section. also where is the best place to buy all the bearings i will need. thank you
Why do you need axle measurements? What are you trying to do?
I think you can find the axle shaft lengths with a thorough search at chevytalk.com.
i need to know because i have 8 axles in the garage of different legeth. need to know whitch ones to use
56 Nomad, Ramjet 502, Viper 6-speed T56, C4 Corvette front and rear suspension
Other vehicles:
56 Chevy 2-door BelAir sedan
56 Chevy 210 4-door sedan
57 Chevy 210 4-door sedan
1962 327/340HP Corvette
1961 Willys CJ3B Jeep
2001 Porsche Boxster S
2003 Chevy Silverado 2500 HD Duramax
2019 GMC Sierra Denali Duramax
Here's another source...
http://www.southeastchevyparts.com/1...ed-_p_173.html
56 Nomad, Ramjet 502, Viper 6-speed T56, C4 Corvette front and rear suspension
Other vehicles:
56 Chevy 2-door BelAir sedan
56 Chevy 210 4-door sedan
57 Chevy 210 4-door sedan
1962 327/340HP Corvette
1961 Willys CJ3B Jeep
2001 Porsche Boxster S
2003 Chevy Silverado 2500 HD Duramax
2019 GMC Sierra Denali Duramax
Bill 1957-427-177-6-410
Note that in both of Cnut's links they got the posi vs. the non-posi lengths backwards. The posi axles are the shorter of the two.