I am trying to source a 700r4 for future installation. Is it necessary to remove the Powerglide frame mount horns - I think it would be for clearance but not sure.
I am trying to source a 700r4 for future installation. Is it necessary to remove the Powerglide frame mount horns - I think it would be for clearance but not sure.
had a 700r4 put in a 55 I had. not necessary to remove them, but I did anyway. better clearance for my exhaust and there UGLY.
ARMY NAM VET, very proud!
56 210 4dr
drive and enjoy them while you work on them, life is to short.
I still use them on my 56 with 700r4, It has CCI turbo mid mount adaptors with a early Camaro crossmember out back. I am not a fan of most side mount conversions unless a Big Block is involved.
You have two choices for this.
1. Use the original front mounts and an aftermarket bellhousing mount kit that bolts to the original bellhousing mount brackets on the frame.
2. Use an engine side mount conversion and a crossmember. You can cut the mount brackets off the frame but you don't have to as they are not in the way. However, if you have (or want) a lowered car, this is the way to go since you can cut the brackets off the frame, allowing you to tuck the exhaust pipes up higher and create some ground clearance.
Good to know, don't want to lower the car, and when the day comes, I might not have to spend time with the sawzall.
A sawzall is not the correct way to remove them, it is all but impossible to do neatly with the body on frame.
Used a sawzall to remove mine, then a harbor freight grinder/sanding wheel...with the body on.
Came out just fine. What tool would you use Sal?
1957 Nomad- LS1/T56 on C4 chassis
1959 Fleetside Apache 1/2 ton, shortbed, big window, 327ci.
I was going to have a 700R4 put in my 55 Chevy 210, I got a message from JEGS saying this wouldn't work in my car, well let me copy and paste their message. ///Brandon Johnson (JEGS Performance) Dec 10, 9:22 PM EST Hello,So of course this has me confused to say the least. I have several friends who own tri fives, especially 55's and they've done this swap with no modifications other than cutting the driveshaft and having it balanced. Can anyone give me some input on this from their own experience? I would like to copy them to Jegs because I don't believe they know what they're talking about. Thanks for any help given.
The 700r4 will not fit the stock tunnel on the car. You will need to make a custom mount and make a tunnel or buy one of the aftermarket tunnels that are sold by other company to fit the Later Gm transmissions to the car.
Brandon Johnson
Jeg's Customer Service
1-800-345-4545
We are dedicated to providing our customers with the very best in selection,
value, same day shipping and lifetime support. Thank you for choosing JEGS!
Tell the idiots at Jegs you can hang a 700R4 from the stock frame horns with CCi adaptor mounts and no floor or firewall modifications.