-
CPP 500 box and 2 1/2" Ram's horn exhaust
Getting ready to switch to power steering and was wondering if a 500 box will fit with my 2 1/2 rams horn manifold's. Currently the stock box fits but it is close. From what I have researched so far, the two boxes are identical size wise but just want to make sure before I get the kit from Jalopina.
HAL
-
Should be no problem, my 56 has SBC and 500 PS with motor in stock location and snug but adequate clearance.
-
Thank You, that is what I wanted to hear.
-
One more thing, is there a difference between a borgeson 600 delphi box and the cpp 500 box?
-
Registered Member
Should fit with about 1/4" clearance. There are better prices out there then from Jalopina (LOL, must be his wife) Auto City Classic sells them for less for one.
-
I have never seen a Delphi or Borgenson box for one of these cars installed. Still a lot of 600 leak jobs around, seeing more CPP 500s all the time.
-
Registered Member
My setup is 500 box with SBC with 3/4 forwards side mounts and it fits with my Stainless Works 1 3/4 headers. Plenty of clearance
-
ok, next question? Is there a difference in pump pulleys between short water pumps and long water pumps or are the brackets the only thing different?
-
Well I ordered the kit from Auto City Classics. $529 vs. $669 at Summit racing. And it came with the correct rag joint for a Ididit column.
Last edited by Hal_396; 08-26-2016 at 07:08 PM.
-
Pulleys are different between swp and lwp. If you have a lwp crank pulley and a swp pump brackets and pulley without AC it will work well. I define work well as belt stays on at 7500 rpm.
I used a 3rd gen Camaro rag joint because it was free and an 80s S10 for same reason.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules