Last edited by chevynut; 04-10-2018 at 05:17 PM.
56 Nomad, Ramjet 502, Viper 6-speed T56, C4 Corvette front and rear suspension
Other vehicles:
56 Chevy 2-door BelAir sedan
56 Chevy 210 4-door sedan
57 Chevy 210 4-door sedan
1962 327/340HP Corvette
1961 Willys CJ3B Jeep
2001 Porsche Boxster S
2003 Chevy Silverado 2500 HD Duramax
2019 GMC Sierra Denali Duramax
Very nice!
Remember the "13"
Actually it includes everything, my first Dana build started with a 4.10 PowerLock that I rescued from one of my old girlfriends fathers 1964 F250 pickup bed trailer. A buddy of mine gave me a wide 8 3/4 Mopar axle housing for doner brakes and axle ends. The $500 were for new Moser axles, new 35 spline side gears and wheel bearings.
While I'm at it, does anyone center the pinion leaving 2 different length axles? I think it's 1/2" off isn't it? The ends I bought have plenty of wiggle room so that's no problem. Is it worthwhile?
Tony
1955 Bel Air Sport Coupe
I always thought that a solid rearend would have different length axles, and the pinion was centered. I don't see why it would have to be off-center. On an IRS the pinion is off-center because the halfshafts must be the same length.
56 Nomad, Ramjet 502, Viper 6-speed T56, C4 Corvette front and rear suspension
Other vehicles:
56 Chevy 2-door BelAir sedan
56 Chevy 210 4-door sedan
57 Chevy 210 4-door sedan
1962 327/340HP Corvette
1961 Willys CJ3B Jeep
2001 Porsche Boxster S
2003 Chevy Silverado 2500 HD Duramax
2019 GMC Sierra Denali Duramax
I'm getting excited to see how the 4.10 gears run. On Wednesday I finally met up with the guy who is cutting and welding the big chevy ends on and adding 1/2" to each side to center my tires (without spacers.) It's going to be difficult to go a couple hundred miles breaking in the gears without getting on it good. I forgot to order a speedometer gear for the th400. Anyone suggest a favorite vendor?
Tony
1955 Bel Air Sport Coupe
Sorry Tony but on HP cars I have never run a speedometer, for example my 67 Camaro has not had one since the 70s, just near felt them necessary.
That's OK, I was going to get it from TCI but they didn't have the right gear or housing. Found a 44 tooth gear and housing on Amazon from a vendor that is new to me. "American Hot Rod Solutions". Much cheaper housing than others. Hope it works.
Tony
1955 Bel Air Sport Coupe