My gawd, it's been months since I posted any progress.
It's been slow, but moving forward.
Have most of the front end and center console wiring done now, and this weekend I fabbed up a set of tire stands so that I could get the wagon up high enough off the ground in a "loaded" position to start fabbing up the exhaust system.
$75 in steel and a few hours later, I made these out of 3/16". I would have gone thicker to 1/4 inch, but my little Lincoln 110v welder struggles at even 3/16, so I chose to go lighter. They seem stout enough though.
IMG_4305.jpg
IMG_4308.jpg
Started to fabricate the exhaust yesterday, and will keep at it this week.