-
Registered Member
Axle Bearing Removal
Hello All,
I'm working on the rear end of my '55 and I'm going to replace the axle bearings. I know they should be pressed off, I have a hydraulic press but I don't think it's big (tall) enough to handle them. I'm wondering if there's any other way to do it? Anybody?
-
You could split the lock ring, and then the outer race and inner race in that order, with a hammer and chisel. Be careful and wear PPE as those pieces will shatter.
But here's the real rub. If you can't press the bearing off, you probably can't press it back on. So why not take it to a shop that can both remove and install with a proper press?
-
Registered Member
Hello Again,
I took my axles to a shop to press them off he ended up burning them off. I couldn't press them off because I didn't have a bearing separator/Splitter. Now I'm going to press them back on, has anyone heated the bearings to help get them on. Does anyone have any tips to make the job easier? Thanks.
-
My 20 ton rebuilt in USA HF works fine for this job, no problem with heating locking rings, the old timer who taught me preferred it. Heating bearings sounds like a bad plan to me. I would have no problem putting axles in freezer. I don't know if it will work but cant hurt.
-
Registered Member
I'm in agreement with MarkM re 'would not heat a new bearing to get it on... except for perhaps putting in the sun for awhile... certainly NO torch type heat...
-
Registered Member
Thanks You all, I might try the sun thing can't hurt! Stay Safe!!!
-
one in freezer, one in the sun might work.
-
Way back in the day before I knew what a press was we would break the old bearing apart and hammer and chisel the old bearing off and using the inner race of the old bearing drive the new bearing on. Then drive the old inner race off.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules