first of all, was`nt sure which section this would be in, since it`s not stock, here we go. `typical 350 small block, no 400 stuff. i tighten the balancer down, and it did`nt bottom out yet, and the pulley is in to far, compared to the "short" pump pulley. can i just shim the crank pulley out? what the hell am i missing? ok, and does the balancer need to bottom out? thanx in advance. ,,,,,,,,,,,i was just thinking to get those "thick" washers to shim it out. HOWEVER, the balancer bolt is only in like a half inch with the spacers on the pulley bolts.