NickP
11-14-2012, 08:49 AM
Some time back, several folks responded to a similar post I did requesting some dimensions. I was excited to receive some great help but in those help dimensions, I noticed some stark differences in the data received. I hate to impose, but if those of you out there with a 57 and no rear bumper in place have time to review this drawing and could post your findings, it would be a great help. I am trying to get this chassis to powdercoat.
Please notice on the drawing that for the dimensions to remain constant, please follow the drawing. I need "A" Horizontal and "A" Vertical along with "B" Horizontal and "B" Vertical. Please note the hole size as, Hole A and Hole B and Know GM Hole.
Many thanks in advance!
http://pic20.picturetrail.com/VOL1600/2283636/5293467/404633400.jpg
Please notice on the drawing that for the dimensions to remain constant, please follow the drawing. I need "A" Horizontal and "A" Vertical along with "B" Horizontal and "B" Vertical. Please note the hole size as, Hole A and Hole B and Know GM Hole.
Many thanks in advance!
http://pic20.picturetrail.com/VOL1600/2283636/5293467/404633400.jpg