PDA

View Full Version : How do you deal with this?



chevynut
02-02-2015, 06:28 PM
The hood bar on a 56 has a "V" in the center but the studs in the hood bar are parallel with the centerline of the car. That means they aren't perpendicular to the hood sheetmetal and when you put a nut on the stud, it doesn't sit flat. Not only does it look bad, but it scratches up the paint and bends the sheetmetal. Is there a good way to deal with this problem?

I found some "leveling washers" but they're way too big.

http://katalog.ganter-griff.de/catalog-images/ganter/4b629365-48b5-46f2-907d-0fae6bf5249b/GN-350.3-Spherical-levelling-washers-Steel-sketch.png

OLKY55
02-02-2015, 07:11 PM
I don't know what angle you need, but have you looked at bevel washers?

chevynut
02-02-2015, 07:14 PM
I know I may be nitpicky about this, but I think it sucks....

4019

I'll come up with something. :)

chevynut
02-02-2015, 07:18 PM
I don't know what angle you need, but have you looked at bevel washers?

Yeah that's probably what I need. The problem is getting the right diameter (1/4" ID) and the right angle. I may have to fab some up out of SS.

http://www.williamsform.com/Shared_Image_Files/Nuts_Couplers_Washers/washer_beveled.jpg

NickP
02-02-2015, 08:08 PM
http://www.mcmaster.com/#standard-washers/=vqqn3i

http://images2.mcmaster.com/Contents/gfx/large/94007a038p3l.png?ver=25011999

chevynut
02-02-2015, 08:18 PM
Thanks Nick, I already looked in McMaster Carr first since I thought it was the obvious place to look, and couldn't find anything. I searched on "washers" but nothing in the pics looked like what I needed. Guess I didn't go deep enough.

They say they only correct up to 4 degrees. I'll have to measure to see if that's enough.

NickP
02-02-2015, 09:53 PM
Most welcome. You could always slot the bottom unit.

567chevys
02-02-2015, 10:17 PM
Great solution !!!

Sid

chevynut
02-09-2015, 08:38 AM
Well I measured the angle at 12 degrees and I saw nothing that would work at that angle so I made my own steel beveled washers. I think this looks a lot better than a stud, washer, and nut anyhow. I'm going to epoxy them in place.


http://www.trifivechevys.com/attachment.php?attachmentid=4019&d=1422933266&thumb=1 4030 4031

JT56
02-09-2015, 08:42 AM
Looks good