Belair beltline molding on a 210

[warren57]

Hey Chevynut, in a past life many years ago, I seem to remember you posting a picture of the oblong holes for the upper Belair trim on a 2 door sedan.
By any chance, do you still have any pictures? I would like to see the upper holes as well as the lower.
Currently I have the stock lower holes for the 210 beltline trim and am getting ready to install the complete Belair stainless.
What's your thoughts on cutting the oblong holes? Drill a hole at each outer edge and the rotary file to connect the holes?
Would like to see a picture of stock holes to see if all the holes are oblong, or a mix of oblong/round.
Appreciate your thoughts, as well as any others.
Thanks

[MP&C]

Warren, here's a post showing how I added the beltline "slots" to new door skins..

http://www.trifivechevys.com/showthread.php/3622-wagon-progress?p=21874&viewfull=1#post21874

[chevynut]

Here ya go Warren. You're welcome to come up and take a pattern off if it if you want to. I'll buy the beer. :)

http://www.trifivechevys.com/attachment.php?attachmentid=5234&stc=1

[warren57]

Warren, here's a post showing how I added the beltline "slots" to new door skins..

http://www.trifivechevys.com/showthread.php/3622-wagon-progress?p=21874&viewfull=1#post21874

Thanks, that pretty much was the only way I could figure out to do it. A slow process, but so is everything else!

[warren57]

Here ya go Warren. You're welcome to come up and take a pattern off if it if you want to. I'll buy the beer. :)

http://www.trifivechevys.com/attachment.php?attachmentid=5234&stc=1


Thanks, I will try and get a trip up to see you planned. Been wanting to see your finished shop too! Had a computer drive go bad so lost some phone numbers. Can you pm me your number and email again?