PDA

View Full Version : Door Bumpers 57 Bel Air



hevychevy
10-17-2019, 05:35 AM
Finishing up the details on my 57 Bel Air. Purchased car partly disassembled. Weatherstrip and door bumpers were removed. No problem with weatherstrip, but now have a 26 piece set of door bumpers and trying to determine where the 8 different types of bumpers go. Any help appreciated. Car now being polished, road ready in a week. Phew! Long road and lotsa cash, but it is beautiful. Will post pics.

carls 56 (RIP 11/24/2021)
10-17-2019, 05:57 AM
maybe get yourself an assembly and shop manual (if you don't have). might show in one of them where they go. looking forward to pics.

scorpion1110
10-17-2019, 05:08 PM
Finishing up the details on my 57 Bel Air. Purchased car partly disassembled. Weatherstrip and door bumpers were removed. No problem with weatherstrip, but now have a 26 piece set of door bumpers and trying to determine where the 8 different types of bumpers go. Any help appreciated. Car now being polished, road ready in a week. Phew! Long road and lotsa cash, but it is beautiful. Will post pics.

There is a document library on this site. Take a look at the forum. I pull assembly pics down all the time.

Scorp

chevynut
10-17-2019, 08:14 PM
I think most of them should be fairly self-explanatory. The only 26 piece set I see is for a 4-door sedan. Is that what you have? Danchuk 224a kit contains bumpers for the doors, trunk, glove box and hood.

https://www.danchuk.com/images/large/224a_l.jpg

hevychevy
10-20-2019, 06:41 AM
Yes, 4 door sedan. Thanks for the replies. Will be looking for assembly diagrams on this site.

chevynut
10-20-2019, 09:22 AM
I don't think the assembly manual shows where these bumpers go, or at least I don't see them. Maybe I can help you get started. The four large round bumpers in the upper left pic above and shown below go on each corner of the hood on top of the hood bumper adjusting studs.

https://encrypted-tbn0.gstatic.com/images?q=tbn:ANd9GcQRfJkOY_xGaaqCJwkqhZLIiEF_b75L-6d7JTxVhfgyD0Q1lkVL


The two directly below them go on the lower corners of the trunk.
https://encrypted-tbn0.gstatic.com/images?q=tbn:ANd9GcTAKa7NuK78ruDXoEilb4pnkgy9jBt89 LTX2Xa_QD6p3v10lVrR

The two small ones at the very bottom go on the corners of the glove box.
https://i.ebayimg.com/images/g/1O8AAMXQVERSxwFl/s-l640.jpg



The two with the two prongs go on the door jamb at the rear of the front doors.
https://encrypted-tbn0.gstatic.com/images?q=tbn:ANd9GcRzMxaDe2MSgTtEmEi0g0Yn-1syZxYc1sp4SSndPqE70B2vHKv9

From what I have found, the two rectangular ones go on the rear doors.

https://encrypted-tbn0.gstatic.com/images?q=tbn:ANd9GcQkuVIj7tRYTOGf0SC4-2xSl3RkYDUng2J8QAKUp_dDoE5Fxz95bw

I think a couple of them go at the top rear of the front doors. If the hole is 1/4" you use the ones with prongs. If the hole is 1/8" you use the ones with screws.
Some of the remainder go on the rear doors but I'm not sure where.

hevychevy
10-20-2019, 01:39 PM
Thanks chevynut. That gets me off to a good start! Appreciate the help