PDA

View Full Version : Brake lines on rear axle



slantflat
12-07-2019, 02:04 PM
Hi everyone.

Got a problem disconnecting the brake lines that run across the rear axle. Oh, 57 Bel Air 283.

On the passenger side tube of the axle there's a block that two lines run out of, going to each wheel cylinder. There's a rubber line going into the front of the block. The block itself is being held by a bracket that is tacked to the axle tube.

As one would guess one of the lines coming off the side will not come out, and also as one would guess I've destroyed it trying to get it out. I ended up cutting the brake line at the B nut.

Also, I can't see how the rubber line going into the front of the block comes off, and it needs to now that I need to take that block off to get the B nut out.

The item holding up progress is that rubber line. Can someone tell me how it comes off, there's no buggering it up because anything left won't fit through the hole in the bracket. There was a clip holding one side tight to the bracket, but that's off and the line still won't come off.

Thanks everyone.

Rick_L
12-07-2019, 02:28 PM
The clip should be all that was holding it. So now it's corrosion or crud. Try tapping with a hammer, or a hammer and chisel.

NickP
12-07-2019, 05:37 PM
http://www.trifivechevys.com/manuals/1957PassengerAssemblyManual/5-3.gif

slantflat
12-07-2019, 08:07 PM
Thanks guys. According to View D, the U clip is holding the block onto the bracket. So the flex line screws into the front of the block?

I'm working on my back with the car on ramps. Trying to hold a flashlight so I can see what's going on. Ah, someday I'll have a decent shop and a lift...