View Full Version : MARK M, ALTERNATOR MOUNTING BOLT
Dave the Wave
01-02-2021, 12:23 PM
hey, did`nt want to steal the thread about mounting the starter, so i started new. anyway, mark, you mentioned that dorman sells these knurled bolts. my alternator bracket, one that bolts on the number 1 header bolts, the 3/8 bolt is not snug in it, and a 7/16 is to big. so, maybe the knurled bolt would make up the little gap. does dorman sell all lengths or just the "kit" for starters? thanx!
markm
01-02-2021, 03:38 PM
All I have ever seen is starter bolts in the Help line. If you have a swp and Accessory holes in heads why not use a 72 Chevy truck bracket/ 72 Corvette. A much better setup.
Rick_L
01-02-2021, 04:19 PM
does dorman sell all lengths or just the "kit" for starters
The bolts are only sold to fit starters - in the specific length needed for starters.
Rustaddict
01-02-2021, 04:50 PM
Could you open the hole up a little bit and go with the 7/16 bolt ?
Dave the Wave
01-03-2021, 02:05 AM
ok, thanks guys, but no holes in the heads. if i drill it,i gotta drill the alt. also, and the bracket. anyway, went out and measured the bolt. same length as the starter bolt, get one this week.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.