View Full Version : Cast Iron Bowtie Intake
markm
01-07-2023, 06:52 PM
I picked up a dual bolt pattern Q-jet Holley cast iron Bowtie high rise SBC intake today, never seen one before, anyone know what they came off. Looks very similar to the aluminum LT-1 intake I run on my 67 Camaro.
567chevys
01-07-2023, 10:03 PM
Hello Markm
Will this help you out ???
https://www.chevrolet.com/performance/engine-components/small-block/intake-manifolds-and-components
Rick_L
01-08-2023, 07:01 AM
If it's "Bowtie", it never came on a production car. Strictly GM aftermarket.
markm
01-08-2023, 04:49 PM
It has holes for 75 up LWP alt and AC brackets, but no EGR and the choke pad is the same as 72 truck or 74 Z28. I am sure its marine or some special dirt track part.
Thanks Sid it is not listed in that link.
markm
01-08-2023, 04:54 PM
Here is a link to one on EBAY. $279.00 ouch
eBay item number:155281940825
markm
01-10-2023, 08:22 AM
I pulled up a Performer off a parts truck yesterday. now I have a decision to make on what to use. It weighs a fraction of what the Bowtie weighs. I really do not think that matters much with the springs and shocks beefed up for caring a snowplow.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.