View Full Version : 1955 chevy Radio Antenna template
tismy55
05-15-2023, 11:51 AM
I need to add a Radio Antenna to my 55 chevy fender but it has no antenna hole for one does anyone have a template so I can drill a hole for my antenna. Thanks for any help. Lewis
chevynut
05-15-2023, 12:09 PM
The antenna hole has to line up with a hole below it in the cowl. I don't know if it would help or not but I have the factory hole in my fender that I could measure. It's a 56 but I think it's the same since the cowl and doors are the same.
tismy55
05-15-2023, 01:29 PM
That would be great atleast it will give me a start . Thanks
I googled this line "1955 chevy bel air antenna template pdf" and it came up with one from Danchuck!
tismy55
05-15-2023, 03:09 PM
Thanks Troy I'll check it out
chevynut
05-15-2023, 06:39 PM
Here's some pics. The measurement is from the point of the fender.
13475
13476
13477
13478
tismy55
05-16-2023, 04:20 PM
looks like 5-1/2" from point to center of hole,, then 1-1/8" from top of fender to top of hole,, then the hole is 1" total . Sound about right.. Thanks for the help
chevynut
05-16-2023, 09:08 PM
looks like 5-1/2" from point to center of hole,, then 1-1/8" from top of fender to top of hole,, then the hole is 1" total . Sound about right.. Thanks for the help
Looks to me more like 5 1/4" square with the fender edge and 1 1/16" up (in the pic) from the inboard edge of the fender to the edge of the hole. That would put it at 1 9/16" to the center of the hole. I should have put the tape through the hole instead of so far down at the fender edge. I can take another pic if you want me to.
tismy55
05-17-2023, 11:47 AM
Thats ok I got it real close that it worked out. Thanks for your help I appreciate it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.