I believe the annual tri-five mag was published by Super Chevy, which folded a couple of years ago, so there is no 2020,2021 or 2022. Before that, I think Super Chevy discontinued the annual as a...
Type: Posts; User: HILLBILLY823
I believe the annual tri-five mag was published by Super Chevy, which folded a couple of years ago, so there is no 2020,2021 or 2022. Before that, I think Super Chevy discontinued the annual as a...
A 500 box, not a 600
many times the rear motor mounts give out and cause trans linkage problems, Check there first
The assembly 57manual gives a dimension from an imaginary line to the frame ball pivot. There is also a vertical dimension from this line to the lower steering box hole in the frame. Subtract the...
Ol'55 (East Coast Chevy) in Doylestown, PA carries what they call "A" arm dust seals. For 55&56 pn 23-164, and for 57, p/n23-166
[QUOTE=Dave the Wave;58777]is it true, you can send a shifter to hurst to get it rebuilt? i heard something about this years ago. thanx.[/QUO There is a guy here in CT that deals in shifters. His...
East Coast Chevy (Ol'55) in Doylestown PA offers exchange with a core.
I am in awe (jealous) of the work you can do.
Model A's have just as many repro parts available as tri-fives, and door skins are available. Snyder's in Ohio, or Bratton's in Maryland both stock an immense inventory. (I have owned a Model A since...
If you use the wagon center section, you will need the wagon bumper guards,(which have marker lights or some other means of having a marker light to be legal, just consider that.
The sure way to tell if it's a 9 inch is to look at the bottom 2 studs that hold the pumpkin into the housing. If it's a 9, you cannot fit a socket onto those nuts,(no room) a wrench must be used.
Thanks for the heads up on seals. I thought I read where T&N was doing some parts again? I'm pretty sure I have a trunk seal squirreled away somewhere, but If it isn't soft and supple, I'll chalk it...
I did try shims, but there was no way to eliminate the degree to which this lid was raised, My car is all apart, and no seals on lid at this point, When I add seals, it may present the problem all...
I don't always come out on the good side of these endeavors, but as they say, even a blind squirrel gets a nut once in a while, LOL
I replaced my trunk lid with a used one in good condition, but after install, I found that the new lid was what seemed to be a 1/4 inch higher than the panel between the front edge of the lid and the...
I am at a loss to understand why you think a 4 dr is "unsafe"? From a structural standpoint, the center pillar and doors would make the roof stronger in a rollover situation, much more so than a...
57 2 dr hardtop rust bucket
Ansonia, CT
No pics yet