Search:

Welcome from Iowa.

Yup, you're correct about these reprints.

I bought a book from this site which is a reprint of a Chevy Sales book. It describes in detail all the info on the '56 models and I think that you will be impressed by its contents. The site has...

Welcome. I'm looking forward to hearing about your car.

I drove big block Mopar cars for years, and I found that Autolite plugs worked the best for me. That's the brand I plan to buy for my '56, when I need new ones.

Have any of you guys seen dual quads on a '56 265 engine before. This one was in Des Moine at the Good Guys show last weekend. It looks original, but I didn't see it as an option in my '56 spec...

I removed the front motor mount on the passenger's side. I loosened the 2 side mount bolts and loosened the exhaust flange bolts. Then I jacked up the transmission and installed a 1/4" shim to...

Thank you Rick_L

OK. Thanks for pointing that out.

OK Rick L. I'll show my ignorance here. I have my car sitting on 4 wooden blocks so it is level like when I'm driving it. I put my angle gauge on the drive shaft and the transmission is 2 degrees...

I couldn't get a good reading on the carb without removing it, so I put my angle gauge on each of the valve covers. They each are pointing 6 degrees upward at the front.

The 350 crate engine in the '56 I bought doesn't sit level. It sits high in the front so that the 17" fan I'm using is very close to touching the bottom of the radiator with a sizable gap at the...

My '56 has a Griffin radiator that is 4 or 5 years old. I bought the car from an estate sale in another state. The car has 2,500 miles on it, and yesterday the radiator started leaking around the...

Ciadella Interiors in Arizona.

Welcome to the site from a Tri Five lover up in Iowa.

The 16-241 is the stock calibration metering rod used in the Edelbrock #1406 carb. The size is (075X047) The orange spring is the stock one for this carb.

Welcome from Iowa.

Welcome from Iowa. You have a great looking ride.

Welcome from Davenport Iowa.

Welcome from Davenport Iowa

Congrats on accomplishing your goal.

Welcome. You have a nice looking PU. Best wishes for success with your projects.

Another place that I've used is H&H Classic Parts for Chevrolets in Bentonville Arkansas. (479) 787-5575

I get most of my parts from Sam's Chevy Parts in Moline, Il. They specialize in 55-57 parts. (309) 797-5757

Our '56 has an aftermarket steering column that uses a center push button for the horn. Our car has an original looking (smaller diameter) steering wheel that uses the factory type horn assembly, so...