Search:

I mean that the yoke is up towards the floor board.

Came back early from our RV trip. Any suggestions on the how to set the pinion angle on the Ford rear end I am putting in my 55? I was thinking of tack welding the pads in at 2 degrees positive and...

Sorry this reply has taken so long to post but being retired I am more busy now than when I was working. I have the rear cut and pasted to get it near the center so I should not have an issue with...

Update. Found out it cost a lot of $$$$$ to put a posi unit in a 10 bolt Chevy rear and all you have is a weak expensive rear end. I did find a Ford 8.8 limited slip diff out of a 2001 explorer...

It was making noise and i first thought it was the transmission, i have a 4 speed Muncie. i pulled the trans and sure enough there was a problem with it. I replaced the rans with a Muncie out of a...

I have talked to some differential people who build rears and they said sometimes with a little cutting and adjusting they could get the 8.8 to line up correctly. i don't have that kink of cash t...

I have a '55 daily driver that I blew the rear end in the other day. I have a chance to buy a (hate to say it a Ford) 8.8 that came out of a 1996 Ford Explorer that is a 3:73 posi. I guess my...