Just joined? Please introduce yourself.

Search:

Type: Posts; User: HILLBILLY823

Search: Search took 0.01 seconds.

  1. Replies
    21
    Views
    3,728

    A 500 box, not a 600

    A 500 box, not a 600
  2. Replies
    5
    Views
    699

    many times the rear motor mounts give out and...

    many times the rear motor mounts give out and cause trans linkage problems, Check there first
  3. Replies
    15
    Views
    4,558

    The assembly 57manual gives a dimension from an...

    The assembly 57manual gives a dimension from an imaginary line to the frame ball pivot. There is also a vertical dimension from this line to the lower steering box hole in the frame. Subtract the...
  4. Ol'55 (East Coast Chevy) in Doylestown, PA...

    Ol'55 (East Coast Chevy) in Doylestown, PA carries what they call "A" arm dust seals. For 55&56 pn 23-164, and for 57, p/n23-166
  5. Replies
    61
    Views
    10,302

    [QUOTE=Dave the Wave;58777]is it true, you can...

    [QUOTE=Dave the Wave;58777]is it true, you can send a shifter to hurst to get it rebuilt? i heard something about this years ago. thanx.[/QUO There is a guy here in CT that deals in shifters. His...
  6. Replies
    13
    Views
    4,113

    East Coast Chevy (Ol'55) in Doylestown PA offers...

    East Coast Chevy (Ol'55) in Doylestown PA offers exchange with a core.
  7. Replies
    8
    Views
    3,110

    I am in awe (jealous) of the work you can do.

    I am in awe (jealous) of the work you can do.
  8. Replies
    8
    Views
    3,110

    Model A's have just as many repro parts available...

    Model A's have just as many repro parts available as tri-fives, and door skins are available. Snyder's in Ohio, or Bratton's in Maryland both stock an immense inventory. (I have owned a Model A since...
  9. Replies
    6
    Views
    1,624

    If you use the wagon center section, you will...

    If you use the wagon center section, you will need the wagon bumper guards,(which have marker lights or some other means of having a marker light to be legal, just consider that.
  10. Thread: 9 INCH

    by HILLBILLY823
    Replies
    22
    Views
    6,624

    The sure way to tell if it's a 9 inch is to look...

    The sure way to tell if it's a 9 inch is to look at the bottom 2 studs that hold the pumpkin into the housing. If it's a 9, you cannot fit a socket onto those nuts,(no room) a wrench must be used.
  11. Replies
    8
    Views
    2,146

    Thanks for the heads up on seals. I thought I...

    Thanks for the heads up on seals. I thought I read where T&N was doing some parts again? I'm pretty sure I have a trunk seal squirreled away somewhere, but If it isn't soft and supple, I'll chalk it...
  12. Replies
    8
    Views
    2,146

    I did try shims, but there was no way to...

    I did try shims, but there was no way to eliminate the degree to which this lid was raised, My car is all apart, and no seals on lid at this point, When I add seals, it may present the problem all...
  13. Replies
    8
    Views
    2,146

    I don't always come out on the good side of these...

    I don't always come out on the good side of these endeavors, but as they say, even a blind squirrel gets a nut once in a while, LOL
  14. Replies
    8
    Views
    2,146

    Trunk lid too high

    I replaced my trunk lid with a used one in good condition, but after install, I found that the new lid was what seemed to be a 1/4 inch higher than the panel between the front edge of the lid and the...
  15. Replies
    26
    Views
    6,358

    I am at a loss to understand why you think a 4 dr...

    I am at a loss to understand why you think a 4 dr is "unsafe"? From a structural standpoint, the center pillar and doors would make the roof stronger in a rollover situation, much more so than a...
  16. Replies
    3
    Views
    1,148

    Just joined

    57 2 dr hardtop rust bucket
    Ansonia, CT
    No pics yet
Results 1 to 16 of 21