Been working on a box to enclose my main power fuses, headlight, horn. and fan relays...
Been working on a box to enclose my main power fuses, headlight, horn. and fan relays...
Nice Job Warren ,
After you get it done you should make them and sell them , I'm sure you could sell a few !!!
Sid
1955 2 DR Post
1937 Chevy Coupe
2023 Ford Super Duty F350 TREMOR
2019 Corvette Z06
1955 Chevy Nomad
1935 Ford 2dr Slant back I have 4
That should clean things up well. Did you make the metal box or is it something you bought? Where are you going to mount it?
56 Nomad, Ramjet 502, Viper 6-speed T56, C4 Corvette front and rear suspension
Other vehicles:
56 Chevy 2-door BelAir sedan
56 Chevy 210 4-door sedan
57 Chevy 210 4-door sedan
1962 327/340HP Corvette
1961 Willys CJ3B Jeep
2001 Porsche Boxster S
2003 Chevy Silverado 2500 HD Duramax
2019 GMC Sierra Denali Duramax
looks good warren, nice job.
ARMY NAM VET, very proud!
56 210 4dr
drive and enjoy them while you work on them, life is to short.
I fabricated the box and tig welded the seams. Going to build an overlapping front cover that wraps the edges about 1/2" with rubber gasket. Should be totally sealed, yet easily opened for fuse/relay changing. Also added a small buss bar to add additional circuits later if needed. The power in (from the alt.) is fused, then splits and each relay is fused, then wire back to the battery. All wires coming into and out of the box go through rubber grommets and will be sealed. One relay is high beam, one is low beam, one horn relay, one fan.
Here it is mounted with internal wiring complete. Batt, alt, ign, etc. relay.fuse box2.jpg
Last edited by warren57; 10-30-2012 at 02:00 PM.