Hey Danny, I have replaced rear crossmembers on a few frames. I had some new ones made, but they're not full width. We cut them inboard of the frame rails and splice them in whenever they're damaged. I have a complete one that I cut off of a 2-piece frame that's in good condition if you want it. It's the type that's riveted in, not welded in, so I don't know how well it will work. It may cost more to ship than to just make a new one. Let me know if you're interested.

On the other hand, they're not that hard to straighten if your old one isn't too badly damaged. I've straightened some pretty bad ones.....the one in the pics below was damaged in shipment when I got it. A little "body work" and it turned out good as new.

20100416_0010.jpg20100420_0046.jpg20100808_0082.jpg