Robert, the shapes are fairly simple....once piece is curved across the top and another piece curved around the inboard side. I was going to make them out of two pieces of aluminum welded together. I don't think I even need a bead roller, just cut the pieces out and weld them together. I guess I may still do that.

I'm getting kinda burnt out working on these panels and I'm looking for a quick way to finish them. It doesn't really matter to me if the armrests are aluminum or fiberglass...they'll work the same either way. I still have the rear side panels to fiberglass too.

I need to get the car down to a bare frame sometime in February to get the frame painted. At least that's what I'm shooting for. I have to get this interior construction done, or at least far enough done that I can take the doors off the body and the body off the frame. I can still work on the console with the body on stands. I guess I could still work on the door panels with the doors off too.