Just joined? Please introduce yourself.
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Header Collector Flange at an Odd Angle

  1. #11
    Registered Member
    Join Date
    May 2012

    Member #:625
    Posts
    3,409
    My luck the next set would not fit the chassis. Hate to say it but I would probably make a correction on collector.

  2. #12
    Registered Member Custer55's Avatar
    Join Date
    Feb 2015

    Member #:2442
    Location
    Custer, WI
    Posts
    640
    I agree that you should cut off the original rear engine mounts. Then return those headers for a set that tuck in above the bottom of the frame. Even when my car sat much higher I had headers that went under the rear engine mounts and they would scrape the ground all the time going in and out of driveways and such.
    You would most likely need to re-design the trans crossmember for exhaust clearance but you will be much happier in the long run with the exhaust all above the bottom of the frame.
    Brian

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •